altim air_knife_time_on ako Trendsetter_VLF Trendsetter_VLF_Auto The time in seconds the firmware will keep the 'air knife' jet on during an unload sequence. The 'air knife' shoots a jet of compressed air under the trailing edge of film media to separate it from the drum and help guide the film on to the unload ramp. uint32
  • 0.750 seconds
    •
  • 0 to 10.000 seconds
    •      This parameter is stored as an integer value of milliseconds. It is entered by the user in seconds and displayed to the user in seconds. The user may enter up to three digits after the (optional) decimal point. cfg
  • ../nvs/altim_cfg_akd.xmlNVS: altim akd
    •
  • ..\..\ShowAllErrors.htmFirmware 0 Error Index
  • ..\..\ShowAllCommands.htmFirmware 0 Command Index
  • ..\..\ShowAllNVS.htmFirmware 0 NVS Index
    •  Updated: Wed Jul 16 19:36:29 2008 PST